Table of Contents
Advertisement
Remove Paper—Output Bin x
FRU
Dual output bin sensor flag
1
271.xx Paper Jam—Check Bin x
FRU
Pass thru sensor and flag
1
assembly
Control board
271.xx Paper jam - Check Bin x, POST complete, first sheet of paper feeds into output
bin x
Note: Before performing the following checks, run the Output Bin X Sensor Test and check for the failing
sensor.
Sensor Test:
NF = Near Full (Upper part of sensor assembly)
F = Full (Lower part of sensor assembly)
P = Pass Thru Sensor
990 Service - Bin x
If displayed, replace the output expander option.
No indication that bin x is full or no indication that bin x is near full
FRU
Dual output bin x sensor
1
assembly
Output expander control
board
Service Manual
2-112
displays, POST incomplete, unable to clear the message
Action
Check the flag for correct operation, binding, broken parts, or
interference from the sensor cable, If incorrect, repair as necessary.
or replace the output expander option.
, POST incomplete
Action
Check the sensor flag for proper operation. If correct, check to make
sure the pass thru sensor cable is correctly connected to J3 on the
control board. Disconnect the pass thru sensor cable from J3 on the
control board and check the voltage at J3-3. The voltage measures
approximately +5 V dc. If incorrect, replace the control board. If
correct, check the voltage at J3-2. The voltage measures
approximately 0 V dc. If incorrect, replace the sensor assembly. If
this does not fix the problem, replace the output expander option.
Action
Check for correct installation of the sensor cable at J5 on the output
expander control board. If either the Bin Full (F) or Bin Near Full (NF)
fail the sensor test then check the voltage at J5-3 and J5-4. The
voltage measures approximately +5 V dc. If the voltage is incorrect,
replace the output expander option. If correct, replace the sensor
assembly.
Advertisement
Table of Contents
