Dell 5310n - Workgroup Laser Printer B/W Service Manual page 157

Service manual
Table of Contents

Advertisement

Tray 1 not recognized as being installed; unable to clear
FRU
Tray 1
1
Integrated card/
2
autocompensator cable
System board
3
Action
Check Tray 1 for damaged or broken autosize fingers. Check for
anything that would prevent the autosize fingers from activating the
paper activate springs and ITC switches.
If a problem is found, repair or replace the tray assembly. If no
problem is found, go to step 2.
Check for correct installation of the cable at J26 on the system board.
If installed correctly, go to step 3. If incorrectly installed, install and
recheck the printer.
Check the continuity between J26-2 on the system board and
ground. It should measure approximately 0 ohms.
Tray 1 Missing
message
Diagnostic information
2-115

Advertisement

Table of Contents
loading

This manual is also suitable for:

5210n5310n

Table of Contents