Signature Button Contact Assembly Removal - Dell 5310n - Workgroup Laser Printer B/W Service Manual

Service manual
Table of Contents

Advertisement

Signature button contact assembly removal

Remove the print cartridge.
1.
Remove the left side door. See
2.
Remove the right cover. See
3.
Remove outer system board shield. See
4.
Disconnect signature button cable from connector J14 on the system board.
5.
On models 200/210/400/410, remove the two screws (A) securing the blower duct.
6.
Remove the signature button contact assembly mounting screw (B).
7.
Remove the assembly signature button contact assembly.
8.
Note: Be sure to route the cable in the same location, as shown (C), when replacing the assembly.
Service Manual
4-76
"Left door removal" on page
"Right cover removal" on page
"Outer shield removal" on page
4-7.
4-9.
4-69.

Advertisement

Table of Contents
loading

This manual is also suitable for:

5210n5310n

Table of Contents