Use
or
to select the margin setting you need to change, and press
3.
The Top margin sign/value pair blinks. This indicates it is the margin value being changed.
T=xxx*
L=xxx*
Use
to decrease or
4.
The message Submitting selection displays, and the original REGISTRATION screen appears with the
beside the previously selected margin setting.
The print registration range is:
Variable Description
B=
Bottom margin
T=
Top margin
L=
Left margin
R=
Right margin
Continue changing the settings by repeating steps 2 through 4.
5.
Print another copy of the Quick Test to verify your changes.
6.
To exit REGISTRATION, press Back (
7.
Quick Test
The Quick Test contains the following information:
Print registration settings
•
Alignment diamonds at the top and bottom
•
Horizontal lines to check for skew
•
General printer information, including current page count, installed memory, serial number, and code level.
•
To print the Quick Test page:
Note: Print the Quick Test Page on letter or A4 paper.
Select REGISTRATION from DIAGNOSTICS.
1.
Press
until the
2.
The message Quick Test Printing... appears on the display.
Once the Quick Test Page completes printing, the Registration screen displays again.
B=xxx*
R=xxx*
to increase the offset values, and press
Value
-20 to +20 Each increment causes
approximately 0.55 mm shift in the
bottom margin.
-25 to +25 Each increment causes
approximately 4 pels shift (at 600
dpi).
-25 to +25
-10 to +10
)
.
appears next to Quick Test.
.
to confirm the value.
Direction of change
A positive change compresses the
image so it appears to move down
the page and a negative change
moves the image up.
A positive change moves the image
down the page and increases the
top margin. A negative change
moves the image up and decreases
the top margin.
A positive change moves the image
to the right, and a negative change
moves the image to the left. No
compression occurs.
A positive change moves the image
to the right, and a negative change
moves the image to the left.
Diagnostic aids
3-5