Error Messages; Error Messages; Clearing The System Configuration - HP D7171A - NetServer - LPr Installation Manual

Chapter 12
If you have TopTools remote management software installed and configured for
use with DiagTools, you can accomplish any of the above tasks remotely.
See the online documentation HP NetServer DiagTools Error Reference and User
Guide for more information on DiagTools.

Error Messages

All errors are localized in the BIOS and displayed in POST.

Clearing the System Configuration

You may need to clear the system configuration if a program has corrupted the
configuration or if incorrect settings made in the Setup utility have made the
display unreadable.
To clear the system configuration, follow these instructions:
1. Log off all users and shut down the network operating system according to
directions in your NOS documentation.
2. Power off the server according to the instructions in Chapter 2, Controls,
Indicators, and Ports.
3. Disconnect the power cord and cables and, if necessary, label each one to
support reassembly.
CAUTION
The power supplies will continue to provide standby current to
the NetServer until their power cables are disconnected.
4. Open the system board access panel (see Chapter 3, Opening and Closing
the HP NetServer, for instructions).
While you can clear the system configuration in the rack, it is
recommended that you remove the system board assembly to perform
configuration changes.
NOTE Refer to Figure 12-1 and the Technical Reference Card on the
system board access for system switch locations and settings.
5. Locate the system switch on the system board assembly, and move the
configuration memory switch, Switch 5, to the "ON = CLEAR CONFIG"
position.
Troubleshooting
127