Installing An Accessory Board In Slot 1; Accessory Board Tray Guidelines - HP D7171A - NetServer - LPr Installation Manual

Chapter 6
17. Use the respective NOS to ensure that the correct PCI board software
drivers are loaded, and verify its correct operation.
18. Restore the NetServer to normal operation.

Installing an Accessory Board in Slot 1

This section explains how to install a PCI accessory board in Slot 1 via the
installed accessory board tray. This tray is used specifically for installing a board
in Slot 1 when the NetServer is mounted in a rack.

Accessory Board Tray Guidelines

Use the following guidelines when installing accessory boards in the accessory
board tray:
l
Install only half-size accessory boards in the tray when the server is
mounted in a rack.
l
Full-size accessory boards should be installed in the tray when the server is
not installed in a rack.
l
Recommended accessory boards for use in the accessory board tray are
listed in Table 6-1.
Table 6-1. Recommended Accessory Boards for Use in Accessory Board Tray
*See explanation of Cases following table.
Half-Size PCI Accessory Board
D2140 1Si DAC
D5013 LAN PCI NIC
D5025 Ultra Wide SCSI Adapter
D6977 Fiber Channel Bus Adapter
D8602A Fiber Channel Bus
Adapter
D6028 RMC Board
Full-Size PCI Accessory Board
D5955 3Si DAC
D9161 4Si DAC
D9351 4Si DAC
Installing Additional Boards
Case 1 Case 2
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No No
No Yes
No No
No No
Case 3
Yes**
Yes**
Yes**
Yes**
Yes**
Yes**
Yes*/**
Yes*/**
Yes*/**
57