10Configuring The Hp Netserver; Introduction; Hp Netserver Navigator Cd-Rom; Using A Separate Workstation To View Navigator Information - HP D7171A - NetServer - LPr Installation Manual

10 Configuring the HP NetServer

Introduction

This chapter describes the following:
l
Configuring the HP NetServer
l
Installing the Network Operating System (NOS)
NOTE

HP NetServer Navigator CD-ROM

Use the HP NetServer Navigator CD-ROM (Navigator) to perform configuration
tasks or view online system documentation. There are two ways to do this.
l
You autorun the Navigator CD-ROM on your NetServer to perform the
configuration tasks.
or
l
You can run the Navigator CD-ROM on any PC or workstation with
Windows 3.1 or greater, Windows 95/98, or Windows NT. You can use the
autorun feature or you can run the installation program form the CD-ROM.

Using a Separate Workstation to View Navigator Information

If you are unable to boot your NetServer, you can run the Navigator CD-ROM
from another PC or workstation. You can view many of the administration
functions, and create diskettes containing necessary tools and drivers.
1. Insert the CD-ROM in the CD drive of a desktop or laptop computer. If the
autorun feature is enabled, the Navigator CD-ROM program will run. If
the autorun feature is disabled, do the following:
a. Go to RUN.
b. Enter D:\launch32.exe where D: is the address of the CD-ROM.
c. Press Enter or Return. The CD-ROM program will run.
The HP NetServer ships with NetRAID as the default. If you
plan to configure mass storage as LVD SCSI, change the
default using the Setup Utility prior to installing the NOS.
93