Step 2: Prepare The Slides - HP D7171A - NetServer - LPr Installation Manual

Chapter 13
2. Hold the template alongside the inside face of the left-front rack column.
Line up the template with the same rack space that the server will occupy.
(The template covers an area four EIA units high, the same height the
server requires.) The template directs you to two holes in the rack column
that are used for mounting the slide. Mark the second and third holes from
the baseline (bottom) future reference.
3. Hold the template alongside the inside face of the left-rear rack column.
The template directs you to the second and third holes in the rack column.
Mark it for future reference.
4. Repeat Steps 1 through 3 for the right-front and right-rear columns.

Step 2: Prepare the Slides

This step requires that you dismantle the LT 6000r's slides so that they can be
installed inside the HP Systems Rack. Refer to Figure 13-3 when dismantling the
slides.
Figure 13-3. Dismantling the LT 6000r Rack Mount Slides (Exploded View)
1. Remove the adjustment knob from both slides.
2. Remove the spring by unscrewing the two #15 Torx screws. Store the
spring and screws in a convenient location in case you ever need to mount
the server in an HP Rack System/E or Rack System/U.
Alternative Rack Mounting
135