Tools Required; Hp Netserver Rack Mount Parts List; Step 1: Mark The Lt 6000R's Position In The Rack - HP D7171A - NetServer - LPr Installation Manual

Chapter 8 Mounting the HP NetServer in an HP Rack System/E or Rack System/U
room's ambient temperature. Make sure that the temperature within the
rack does not exceed 35 C (95 F).
Reduced Air Flow. As you mount equipment in the rack, make sure that
you allow enough air flow for safe operation of the equipment.
Mechanical Loading. Uneven mechanical loading within the rack can
cause hazardous conditions. Plan the placement of equipment in the rack to
make sure that this problem does not occur. Mount the heaviest
components in the bottom of the rack, and mount all components as low in
the rack as is practical.
Circuit Overloading. Make sure that the total configuration of equipment
in the rack does not overload the supply circuit. To this end, check the
nameplate ratings on all equipment. Consider the effect of circuit
overloading on overcurrent protection and supply wiring.
Reliable Grounding. Maintain reliable grounding of rack-mounted
equipment. Give particular attention to supply connections that are not
direct connections to the branch circuit; the use of power strips, for
example.

Tools Required

A marking pen is required for marking the position of the slides on the rack
columns when using the rack installation template.

HP NetServer Rack Mount Parts List

Makes sure that the rack-mount kit that accompanies the LT 6000r contains the
following parts:
Table 8-1. Parts for Rack Mount Kit
Quantity
2 Slides
1 Template

Step 1: Mark the LT 6000r's Position in the Rack

Use the rack-mount template to mark out four EIA units for positioning the
LT 6000r in the rack.
This chapter tells how to mount the HP NetServer LT 6000r in an HP Rack
System/E or Rack System/U (refer to Figure 8-1). If you have the older HP Rack
Description
79