HP D7171A - NetServer - LPr Installation Manual page 81

Chapter 7
Figure 7-5. Opening the Latches and Installing the Processor
5. Align the processor over the open slot so that the heat sink faces up for
Slots 1, 2, and 3; and down for Slots 4, 5, and 6.
6. Slide the processor into the slot until it's fully seated.
7. Close the latches to seat the processor firmly into its connector.
8. Replace the processor cage access cover, and tighten the thumbscrew.
9. Install the corresponding VRM by aligning the VRM with its slot and
inserting it in place. The component portion of the VRM faces down,
toward the system board. See Figure 7-6.
Installing Additional Processors
73