Configuring The Scsi Host Adapter; Installing Hot-Swap Mass Storage; Removing A Filler Panel - HP D7171A - NetServer - LPr Installation Manual

Chapter 4

Configuring the SCSI Host Adapter

In order to verify or modify SCSI host adapter settings, or to low-level format
SCSI drives or verify SCSI media, run the Symbios (SCSI) Configuration Utility.

Installing Hot-Swap Mass Storage

CAUTION
Protect the drive from static electricity by leaving it in its
anti-static bag until you are ready to install it. Before handling
the drive, touch any unpainted metal surface to discharge
static electricity. When you remove the drive from the anti-
static bag, handle it only by the frame.
Do not touch the electrical components. Place the drive on the
anti-static bag whenever you set it down.
Hard disk drives are very susceptible to mechanical shock and
can be damaged by a drop as short as one-quarter of an inch.
Take care when unpacking and handling the drive. If the drop
would crack an egg, it will damage the drive.

Removing a Filler Panel

To remove a filler panel (Figures 4-3 and 4-4), follow these steps:
1. Press the locking latch, and insert your fingers.
Installing Mass Storage Devices
37