HP D7171A - NetServer - LPr Installation Manual page 136

Hp netserver lt 6000r installation guide
Hide thumbs Also See for D7171A - NetServer - LPr:
Table of Contents

Advertisement

Chapter 12
6. Close the system board access panel, plug in the power cords, and power
on the HP NetServer. The following message appears.
This configuration has been cleared. Set the Clear
Config switch to the OFF position before
rebooting.
7. Power off the server, disconnect the power cords, and open the system
board access panel.
8. Return Switch 5 to the OFF position.
9. Close the system board access panel and reconnect the power cords and
cables.
10. Restore the server to normal operation.
11. Power on the server. The following error message might be displayed:
0012-34 : Incorrect System Configuration
12. Press the [F2] function key, answer "Yes" to save the configuration, and
exit the setup utility.
128
Figure 12-1. System Switch Settings
Troubleshooting

Advertisement

Table of Contents
loading

Table of Contents