HP D7171A - NetServer - LPr Installation Manual page 100

Chapter 9
NOTE
If you have a console switch box, refer to the switch box's user
guide for instructions on connecting the monitor, keyboard, and
mouse.
2. Connect each of the power supply module's power cords to the power
receptacles on the rear panel.
3. If you have a UPS installed in the rack, power on the device. Use the
supplied serial cable to connect the UPS to the HP NetServer. Refer to the
user guide included with the UPS and to the HP NetServer Rack
Installation Road Map for additional information.
4. Connect the monitor's power cord to an AC power outlet.
92
Connecting the Monitor, Keyboard, and Mouse
Figure 9-1. HP NetServer LT 6000r Ports