HP D7171A - NetServer - LPr Installation Manual page 67

Chapter 6
NOTE For Case 1 (from Table 6-1), the NetServer can remain
installed in the rack. For Cases 2 and 3, the NetServer must be
removed from the rack, and you must remove both slides from
the chassis before you can open the access panel.
NOTE
It is recommended to remove the NetServer from the rack
before installing a full-size accessory board in the accessory
board tray.
NOTE
Read label on accessory board access panel before installing
the board.
Figure 6-5. Inserting the Accessory Board into Tray
Read label before
installing accessory
board.
(Half-Size, Half-Height Board Shown)
Installing Additional Boards
59