HP D7171A - NetServer - LPr Installation Manual page 117

Chapter 10
3. If necessary, use the arrow keys to move to the Power-On Password menu
selection, and press Enter.
The Power-On Password is highlighted by default when the Security menu
is selected.
The first line in the menu, "Administrator Password is [Set or Not Set]":
If no password has been set, then "Not Set" appears in the field. If this
is the case, you are not allowed to make any selections in this menu
until you set an administrator password.
The administrator password controls access to the Setup Utility and its
settings. The User Password ahs only limited access to the Setup
Utility, such as date, time, and password.
If "Set" is in the field, you can change the password or make other
selections in the menu. However, you must start with the user
password, but can choose to skip setting the user password.
NOTE You must set the administrator password before changing a
user password or configuring the HP NetServer to boot with a
password.
4. Press Enter to enter a new password or change the old one. A pop-up
menu appears: "Set Power-On Password." If no password has been entered,
the "Enter New Password" field is highlighted.
If a previous password has been entered, the "Enter Old Password" field is
highlighted.
5. Enter the password in the appropriate field, and press Enter. The password
is accepted, and the "Re-Enter New Password" or "Enter New Password"
field is highlighted. For security reasons, the password does not appear on
the screen.
6. If necessary, enter the new password in the "Enter New Password" field.
7. Enter the new password in the "Re-Enter New Password" field. After
re-entering the new password, a pop-up menu is displayed, asking you to
confirm your selection.
NOTE
To leave the pop-up menu without entering a password, press
the Esc key.
Configuring the HP NetServer
109