Download Print this page

HP D7171A - NetServer - LPr Installation Manual: Step 5: Install The Cable Management Arm

Hp netserver lt 6000r installation guide.
Hide thumbs

Advertisement

Chapter 13

Step 5: Install the Cable Management Arm

The LT 6000r's cable management arm (Figure 13-12) is used to route all power
cords and cables from the NetServer. It is attached to the left-hand rear panel of
the NetServer and the left rear column on the rack.
Figure 13-12. LT 6000r Cable Management Arm
Use these instructions to install the arm:
1. Install the chassis bracket to the left-hand rear panel of the NetServer as
shown in Figure 13-13.
a. Install two Torx 6-32 screws into the mounting holes on the left-hand
rear panel of the chassis.
b. Fit the chassis bracket holes over the screws so that it locks into place.
c. Tighten the screws to secure the chassis bracket to the rear panel.
144
Alternative Rack Mounting

Advertisement

Chapters

Troubleshooting

   Related Manuals for HP D7171A - NetServer - LPr

Comments to this Manuals

Symbols: 0
Latest comments: