Clearing Cmos - HP D7171A - NetServer - LPr Installation Manual

Chapter 10
1. [Bootable Cards]
2. [#30 ID01 LUN0 HP
3. [#30 ID01 LUN0 HP
The server attempts to boot the NOS on the first hard drive (or DAC or
SCSI board) found in the list. If no NOS is found, the system tries to boot
from the next hard drive in the list until a NOS is found.
6. Use the plus (+) or minus (-) key to move the desired hard drive to the top
of the list.
The hard drive boot list has a maximum capacity of 8 logical drives.
If a bootable Disk Array Controller (DAC) board is used, the RAID
array is seen as a single logical drive.
If more than 8 logical drives are connected to the server, drives 9 and
above (including the DAC or SCSI boards, and the drives connected to
each) will not be recognized by the Setup Utility.
You will not be able to enter the Setup Utility to make changes to these
logical devices during the boot process.
However, these devices will be properly recognized and activated by
the respective NOS.
For more information about selection guidelines, refer to Information
Assistant on the HP NetServer Online Documentation CD-ROM.
7. Press Esc to exit the Hard Drive menu.
8. Press Esc again to exit the Boot Settings menu.
9. Use the right-arrow key to select the Exit menu.
10. Choose "Exit Saving Changes" from the list of options, and press Enter. A
dialog box appears, asking you to confirm your decision.
11. Choose "Yes," and press Enter. The server will reboot.

Clearing CMOS

The Setup Utility does not provide a method of clearing CMOS from within the
utility. To clear CMOS, you must use the configuration switch on the system
board.
1. Shutdown and power off the server and open the system board access
panel.
2. Set Switch 5 on the configuration switch from the OFF position to ON. See
Figure 10-2.
112
Configuring the HP NetServer
4.2GB A]
4.2GB A]