HP D7171A - NetServer - LPr Installation Manual page 153

Chapter 13
NetServer rear panel
Torx 6-32 screws
Figure 13-13. Installing the Cable Management Arm to the
2. Install the rack bracket to the left-hand rear column on the rack as shown in
Figure 13-14. The bracket's position should be in line with the chassis
bracket.
a. Use the template to locate and mark the two holes for installing the rack
nuts.
b. Install two rack nuts and two M5 screws to the left-hand rear column.
Note that there are two holes between the nuts and screws.
c. Fit the rack bracket holes over the screws so that it drops into place.
d. Tighten the screws to secure the rack bracket to the column.
NetServer Rear Panel
Alternative Rack Mounting
Chassis bracket
145