Changing Internal Device Boot Priority - HP D7171A - NetServer - LPr Installation Manual

Chapter 10
21. To change one of the passwords at a future date, return to the Security
menu, and repeat Steps 3 through 7.
NOTE The HP NetServer lets you reset the password by toggling
Switch 6 on the system switch that is located on the system
board.

Changing Internal Device Boot Priority

You can change the boot priority of the HP NetServer's internal mass storage
devices. To do this, follow these instructions:
1. Select "Boot Settings" from the Configuration menu, and press Enter.
The Boot Settings screen appears, similar to the following:
Floppy check:
Summary screen:
Quick Boot mode:
Boot Device Priority
Hard Drive Priority
2. Use this down-arrow key to move to the "Boot Device Priority" field.
3. Press Enter to change the boot order. A list appears similar to the
following:
1. [CD-ROM]
2. [Flexible Disk]
3. [Hard Drive]
4. [Network Boot]
This list provides the current boot order of the internal device types,
including a NIC in the HP NetServer with a boot PROM, and connected to
a network. If the [Hard Drive] selection is moved to the top of the boot list,
it will use the hard disk drive selected in Steps 6 through 8 to the boot the
system.
To change the order, use the up and down-arrow keys to select one of the
device types. Then use the plus (+) or minus (-) key to move a device type
up or down the list.
4. Press Esc to exit one level to the "Boot Settings" menu.
5. To change the hard drive boot order, scroll to "Hard Drive Priority," and
press Enter.
A hard drive boot list similar to the following appears:
Configuring the HP NetServer
[Disabled]
[Enabled]
[Enabled]
111