Accessing Pci Slot 1 - HP D7171A - NetServer - LPr Installation Manual

Chapter 3

Accessing PCI Slot 1

To access PCI Slot 1:
1. Shut down and power off the NetServer.
2. Disconnect all power cords and cables.
3. Remove the NetServer from the rack.
NOTE
Slot 1 uses a special PCI tray for installing certain accessory
boards. Some accessory board require that the NetServer be
dismounted from the rack in order to install the board. Certain
other boards can be installed in the tray while the NetServer is
mounted in the rack. For a list of accessory boards and
conditions in which they are installed in the PCI tray, refer to
Chapter 6, Installing Additional Boards.
4. Unscrew and remove the two #15 Torx screws from the bottom hinge on
the access panel.
5. Press down on the panel latches, and pull open the access panel
(see Figure 3-9).
Figure 3-9. Opened Accessory Board Access Panel, Exposing Slots 1
Opening and Closing the HP NetServer
through 6
31