HP D7171A - NetServer - LPr Installation Manual page 37

Chapter 3
Figure 3-7. Accessory Board Access Panel
WARNING Do not leave the accessory board access panel open for more
than 30 minutes while the NetServer is powered on. Doing so
might cause the server to overheat.
To open and close the accessory board access panel, follow these steps:
1. Extend the rack's anti-tip foot and slide out the NetServer until the slides
lock.
2. Press down on the accessory board access panel latches and open the panel
(see Figure 3-8). This exposes PCI Slots 2 through 6.
Opening and Closing the HP NetServer
29