Install License Command; Using The Configure Utility - Xerox DocuPrint 180 Configuration Manual

Install License command

Using the Configure utility

XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
This command is used for VIPP licensing prior to DocuPrint NPS
release 1.6. It is no longer used.
Access level Administrator
Syntax Install License <v1> <v2> <v3> <v4>
Arguments Values for license. Enter each value when prompted. These values
are case sensitive and are valid only in the DocuPrint for which they
were issued.
The Configure utility allows you to review and update the
configuration of your DocuPrint NPS. Most configuration values
supplied during installation can be viewed, printed, and modified long
after the installation is complete. Configuration values can also be
saved on a diskette for later restoration. When you restore values,
the system is automatically reconfigured based on the restored
values.
You access the Configure utility at the PS-Admin> prompt
Configure. You will be prompted for the appropriate password.
You can also access this utility in Wizard Mode or from the UNIX shell
when you enter Configure.
Access level Administrator
Syntax Configure
You will be prompted to enter the UNIX superuser password.
Arguments A list of menu options appears. Enter your selection at the prompt.
1. Print report of installation questions and answers for this
DocuPrint.
2. Print report of all configuration parameter values.
3. Review standard installation questions and change answers to
some or all.
4. Review key system parameters and change values.
5. View and change individual parameter values.
6. Re-initialize some or all of the DocuPrint software.
7. Back up current configuration values.
8. Restore configuration values from previous backup.
9. Exit the configuration program.
USING UTILITY COMMANDS
2-11