Xerox DocuPrint 180 Configuration Manual page 154

SETTING SYSTEM DEFAULTS
5-20
Tint
Indicates a value between 0.5 and 1.0, where the smaller the
number, the darker the tints become. This parameter only
affects the imaging of PostScript jobs.
Recommended values for darkening levels are as follows:
•
Slight darkening
•
Medium darkening
•
Heavy darkening
SampledBlackSnap
Indicates a fractional value by which the printer adjusts the scale
factor of sampled blacks in Interpress jobs. The value for this
parameter must be between 0 and 1. You may need to adjust
this value for printing Interpress masters created for earlier
versions of Interpress that do not rescale sampled blacks. This
parameter only affects the imaging of Interpress jobs.
Using a small fraction for this value is recommended. For
example, 0.06 allows the scale factor to be adjusted upward or
downward by approximately 6%.
FatScanConversion
Indicates whether or not PostScript fine features will be
enhanced. The default selection is FALSE.
Example This example shows the results of the Change Imager Parameters
command:
PS-admin> change imager parameters
Enter the line thickening value: 1.0
Enter the font thickening value: 2.0
Enter the tint value: 0.9
Enter snap value for sampled blacks: 0.06
Use Fat Scan Conversion: Yes
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
0.9
0.75
0.5