Xerox DocuPrint 180 Configuration Manual page 78

USING UTILITY COMMANDS
Modem switch settings
Disable modem
2-20
On the bottom of the modem are DIP switches that must be properly
set for the modem to function. The recommended settings for the US
Robotics Courier V.Everything modem are:
Table 2-4.
Use the Disable Modem command to disable Port A for incoming
calls. This command terminates the existing modem connection and
refuses any future connection. After you use the Disable Modem
command, use the Start All command to start printing and queueing.
Access level Administrator
Syntax Disable Modem
You will be prompted to enter the Unix root password.
Arguments None
Note: If it is the policy at your site to disconnect the modem for
security reasons, power off the modem and, if required, physically
disconnect the modem cable from your system once the remote
session is complete.
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
Modem DIP switch settings
Switch Setting
1 OFF
2 OFF
3
4 OFF
5 OFF
6 OFF
7 OFF
8
9
10 OFF
Position
UP
UP
ON DOWN
UP
UP
UP
UP
ON DOWN
ON DOWN
UP