Xerox DocuPrint 180 Configuration Manual page 261

Configuring DocuPrint NPS for XDOD/DigiPath
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
13. 13Handling XDOD/DigiPath
This chapter describes how to install NFS for DigiPath/XDOD jobs,
and provides instructions for handling problems with print jobs from
XDOD/DigiPath clients.
Note: The system administrator must enable FTP on the DocuPrint
NPS to print from XDOD 4.0. During installation, or using Configure,
answer "yes" to "Enable FTP (Required to retrieve print clients with
FTP from other machines on the network)?"
Note: DocuPrint does not support NFS except in conjunction with
XDOD/DigiPath products.
To enable some DocuPrint features, you must specify certain options
when you install DocuPrint Printer Controller software. During
installation, the installation script displays the following prompt:
Set up XIPP prescan filter for XDOD clients (Y or
N) [n]:
Enter y (or yes) at this prompt.
You should also set up a separate subdirectory on DocuPrint for
each application that transfers files to it. The name of the
subdirectory should match the <appName> used in the pathname to
transfer files to DocuPrint, as described in "Importing the DocuPrint
directory".
Use an installation script to create the <appName> subdirectory (or
subdirectories). Run this script after normal DocuPrint installation is
successfully completed. You cannot use NFS to create these
subdirectories on DocuPrint.
jobs
13-1