Table of Contents
Advertisement
Installation
Checking the Installation Kit
1. Unpack the container.
a. If ordered, remove the 7017SF
conversion kit box. Set it aside.
b. Remove the top cardboard spacer.
c. Remove the box.
d. Remove the recording paper and
handset from slots in the foam spacer.
e. Verify that the following contents are
included in the box:
•
Power Cord
•
Telephone Line Cord
•
Job Cards (1 Set of 15 cards)
•
Xerox CLEAN-UPS
•
Customer Assistance Label
•
Document Catch Tray
•
Output Tray
•
Operator Guide
l
•
Operator Manua
T
•
elephone handset
•
Telephone number label
RX (Only)
1. Verify that the following contents are
included in the carton:
•
7017 Terminal
•
7017 SF conversion kit box, if ordered.
•
Output Tray
•
Document Catch Tray
•
A4 Recording paper
•
1-A4 Document carrier
•
1-B4 Document carrier
•
2 sets of Job Cards 1 for A4 and 1 for
B4 (15 cards each set)
•
Operator Guide
•
Control Panel overlay in English
•
2 - Product identification Labels (7017
Label and 7017 SF label).
Telecopier 7017 / 7017SF
RX (Only) Checking Individual Country
Installation Kit (locally sourced)
•
Telephone Line Cord
•
Power Cord
•
Log Book
l
•
Operator Manua
•
Control Panel overlay (translated)
•
PTT labels
•
Other Item required by Country
Unpacking the Terminal
1. Remove the styrofoam packaging from the
top of the terminal
CAUTION
Do not lift the terminal by the telephone
cradle; It will not safely support the weight of
the terminal.
2. Position the terminal
a. Remove the terminal from the carton by
grasping the bottom of the terminal
with both hands and lifting.
b. Position the terminal at the site selected
by the customer.
3. Prepare the terminal
a. Remove the plastic cover from the
terminal.
b. Remove all tape and the cardboard
shield from the terminal.
c. Remove the 3 pieces of protective
plastic film from the control panel.
6/88
www.printcopy.info
6-7
Install the Customer Assistance label
1. Locate the customer assistance label.
Record the following information on the
customer assistance label:
• Serial number.
• Customer assistance telephone number.
2. Locate the Serial Number Plate.
a. Raise the upper scan cover until it is
completely open.
b. Locate the Serial Number Plate on the
inside of the right hand frame.
3. Record the serial number.
a. On the bottom line of the customer
assistance label, with a pen, record the
serial number .
b. Record the serial number in the
"Operator Manual" on the page titled
"Requesting assistance."
4. Record customer assistance telephone
number on the customer assistance label.
a.
On the top line of the label, with a
pen, record the customer assistance
telephone number listed below:
1+(800) 527-0214
5. Close the upper scan cover and press firmly
to latch.
6. Install the customer assistance label.
a. Remove the protective cover backing
and carefully position the cover over
the label.
b. Place the label on top front of left cover
or on the cradle.
RX (Only)
Record all necessary details required by your
organization.
Installation
Advertisement
Chapters
Table of Contents
