Show Default Media; Setting Feeder Tray Attributes; Set Tray And Set Tray Default - Xerox DocuPrint 180 Configuration Manual

Show Default Media

Setting feeder tray attributes

Set Tray and Set Tray Default

XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
Use the Show Default Media command to show size, type, color, and
weight for the default media.
Access level Administrator, operator, user
Syntax Show Default Media
Arguments None
Example This example shows the output of the Show Default Media
command:
PS-op>show default media
Site default medium is USLetter::white:75
The Set Tray command (administrator or operator level) allows you
to specify what type of media is loaded in your printer feeder trays.
You must use the Set Tray command whenever you change the
media in a tray. You can also match the attributes of one tray to those
of another tray.
Note: The Set Tray command and related commands cannot be
used for a tray that is being used by the current job, or while the IOT
is warming up.
For instructions on loading feeder trays, see "Loading paper" in the
Guide to Performing Routine Maintenance.
Use the Set Tray command to specify what type of media is loaded
in your printer feeder trays.
Before using this command ensure that all trays are in the feed
position.
Note: If you do not indicate the color or weight, the system uses the
values of the default media.
Access level Administrator or operator
SETTING SYSTEM DEFAULTS
5-3