Xerox DocuPrint 180 Configuration Manual page 231

Install PCLFonts from Floppy
Deleting fonts
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
Use the Install PCLFonts from Floppy command to install HP PCL
fonts onto the Printer Controller from a floppy diskette.
Access level Administrator
Syntax Install PCLFonts From Floppy
Argument None
Example Installing PCL fonts from a floppy diskette:
PS-admin>Install PCLFonts From Floppy
Floppy disk inserted? ("No" to quit): y
Do you want a confirmation prompt for each file? y
Copying files from floppy - please wait ...
Note: If the diskette differs in density from the previous diskette or
from the default format, the following messages may appear:
fd0: read failed (40 1 0)
fd0: bad format
fd0: read failed (40 0 1)
fd0: bad format
The operating system eventually determines the correct format
unless the format is unrecognizable or the diskette is damaged.
Note: The message "No font files found on floppy" appears if no
appropriate fonts are found on the diskette. "READ FAILED [nn nn
nn]" and "fd0:CRC error blk nnn" messages may indicate that the
diskette is damaged.
You can use the Delete Fonts command to delete all installed
PostScript or PCL fonts, a specific pattern of installed fonts, or a
specific installed font file on the Printer Controller.
Before you delete fonts, enter the Stop Printing command and then
enter the List Documents command to ensure that there are no jobs
being processed.
After you delete fonts, enter the Restart Sequencer and Start Printing
commands.
Note: If you are using a MICR system, you should be sure to use
the Restart Sequencer command after deleting MICR fonts. This
procedure clears MICR fonts from system memory.
MANAGING FONTS
10-3