Setting Imager Parameters; Show Imager Parameters - Xerox DocuPrint 180 Configuration Manual

SETTING SYSTEM DEFAULTS

Setting imager parameters

Show Imager Parameters

5-18
Imager Parameter commands adjust the imaging level of PostScript
and ASCII print jobs only. They control the rendering of lines, fonts,
tints, and fine features.
•
The Show Imager Parameters command displays the current
values of the imager parameters.
•
The Change Imager Parameters command changes the current
values of the imager parameters for PostScript and ASCII only.
•
The Restore Default Imager Parameters command resets the
imager parameters to the default values.
You must enter the Restart Sequencer command after you change
or restore default imager parameters for the values to take effect.
Note: The imager parameters do not affect the quality of bitmap
graphics and bitmap fonts.
Use the Show Imager Parameters command to display the values of
the imager parameters.
Access level Administrator
Syntax Show Imager Parameters
Arguments None
Example This example shows the results of the Show Imager Parameters
command:
PS-admin> show imager parameters
LineThicken: 0.3
FontThicken: 0.0
Tint: 1.0
SampledBlackSnap: 0.0001
FatScanConversion: FALSE
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM