Xerox DocuPrint 180 Configuration Manual page 169

Show Profiles
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
6.
The Profile commands show, create, and set input and output
profiles. You use these commands only if your printer is configured
with an optional third party input or output device. (Optional input
devices are available only for Model 96, 4635, and 180 NPS
printers.)
•
The Show Profiles command lists the profiles that have been
set for your optional input and output devices.
•
The Create Profile command creates a profile for your optional
input or output device.
•
The Set Profile command sets a profile you've created for your
optional input or output device.
Note: You must create a profile before you can set it.
Personality Profile parameters for your output devices are set during
the initial installation of your DocuPrint NPS, but you can create
profiles for optional input and output devices as required using
setoutputdevice parameters.
The rest of this chapter provides the syntax and arguments for these
commands.
Use the Show Profiles command to show profiles for optional input
and output devices.
Access level Administrator
Syntax Show <"Input" |"Output"> Profiles
Arguments <"Input" |"Output">
Specifies that the profile is for an input or output device.
6Input and Output profiles
6-1