Eject Floppy; Format Floppy; Copy Documents To Floppy - Xerox DocuPrint 180 Configuration Manual

USING UTILITY COMMANDS

Eject Floppy

Format Floppy

Copy Documents to Floppy

2-2
Use the Eject Floppy command to eject a diskette from the diskette
drive.
Access level Administrator
Syntax Eject Floppy
Arguments None
Note: If you need to use the UNIX procedure to mount a floppy,
refer to the chapter "Using Wizard Mode or UNIX shell."
Use the Format Floppy command to format a diskette in the diskette
drive.
Access level Administrator
Syntax Format Floppy
Arguments None
Use the Copy Documents to Floppy command to copy documents to
a floppy diskette. To copy documents:
1. Enter stop printing.
2. Put a diskette into the diskette drive.
3. Enter copy documents to floppy.
See the syntax and arguments below.
4. Enter yes to confirm the document(s) to be copied and to
confirm that the diskette is inserted into the diskette drive.
Any selected documents that have not been completely printed,
canceled, or aborted are copied to the diskette in UNIX compressed
bar format. A file name is generated for each document as a
printerName concatenated with the docID and with a .document
extension. An .attrs file is also written for each document. This is an
ASCII file showing the document attributes as shown in Service
Mode. One additional file named printerName.printerStatus is written
to the diskette (an ASCII file of the printer status as shown in Service
Mode).
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM