Using The System Interface; Accessing Administrator Or Operator Commands - Xerox DocuPrint 180 Configuration Manual

Accessing administrator or operator commands

XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
1.
This chapter describes the user interface for entering commands
available to the DocuPrint NPS system administrator or operator. It
also identifies commands for changing operator and administrator
passwords.
DocuPrint NPS offers three access levels for Printer Controller
commands: user, operator, and administrator. Commands at the
administrator and operator levels control most functions of the Printer
Controller. There is also a separate access level for your service
technician.
Syntax Privilege <Access level> <password>
Arguments <Access level>
Administrator
Operator
No argument or User
Procedures To access administrator-level commands:
1. At the PS> prompt, enter privilege administrator.
2. Enter the administrator password if it is set.
If the PS-admin> prompt is not displayed and you see one or more
status messages, press <RETURN> to display the prompt.
To access operator-level commands:
1. At the PS> prompt, enter privilege operator.
2. Enter the operator password if it is set.
If the PS-op> prompt is not displayed and you see one or more status
messages, press <RETURN> to display the prompt.
Before you leave the system unattended, return to the user level of
commands by entering privilege user at the prompt.

1Using the system interface

Allows access to all commands. Requires administrator
password.
Allows access to the subset of commands available to
operators. Requires operator password.
Allows access to a limited set of commands that do not
allow managing jobs or the system. No password required.
1-1