Xerox DocuPrint 180 Configuration Manual page 160

SETTING SYSTEM DEFAULTS
5-26
•
<Language>
Specify the language value you wish to use. Valid language
values are: ENGLISH, FRENCH, ITALIAN, GERMAN,
SPANISH, PORTUGUESE, NORWEGIAN, DUTCH, FINNISH,
DANISH, and SWEDISH.
<Symbol set value>
Specify a default value from the supported symbols sets. This is
the default symbol set that will be used if one is not included with
the job. The default is 8U (symbol set ID for Roman-8). You can
use either kind1 or symbol set ID numbers when specifying the
value. Refer to the section on "PCL symbol sets."
Example This example shows the usage of the Change PCL Parameters
command:
You can also enter the command on one line as shown below.
Example This example sets the values to the same ones shown above:
PS-admin>change pcl parameters true true true false english 8u
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
When using the commands to list or print fonts, fonts that
have been downloaded will not be listed. Only those that
have been installed at the printer controller will be
listed.
change pcl parameters
Ã
ENGLISH
8U
TRUE
TRUE
TRUE
FALSE