Xerox DocuPrint 180 Configuration Manual page 182

CHECKING SYSTEM STATUS AND DISPLAYING BILLING METERS
Print Billing Report
8-6
Billing Meter E
Counts all the successfully completed sheets delivered to the
intended output destination.
Billing Meter F
Same function as Billing Meter A except that it can be cleared by
the system.
Billing Meter H
Counts all the successfully completed duplex sheets delivered to
the intended output destination.
Billing Meter J
Same function as Billing Meter A except that it counts sheets
printed while the printer is in diagnostic mode.
Billing Meter L
Counts the total number of successfully completed color sheets
printed in highlight color. Sheets using black only are recorded
by this meter. (Used only for highlight color printers.)
Billing Meter T
Same function as Billing Meter A.
Use the Print Billing Report command to print billing meter data. You
can report meter readings on a monthly or quarterly basis, or you can
estimate monthly or quarterly usage and reconcile your estimates
with meter readings taken by your service representative during
regular maintenance or service calls. If you report readings, you must
review the billing-meter data during the last five days of each month
(when the system is idle) and transmit the data to Xerox.
Access level Administrator or operator
Syntax Print Billing Report
Arguments None. However, if the service representative did not enter the
System ID and Customer ID during installation, the system prompts
you to enter the information before you can print the billing report.
System ID has not been set. Enter system ID to use
for the report:
Ask your service representative to enter the System ID and
Customer ID.
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM