Remote Monitoring Configuration; Rmon History Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Remote Monitoring configuration

Command: /cfg/rmon
[RMON Menu]
Remote Monitoring (RMON) allows you to monitor traffic flowing through the switch. The RMON MIB is
described in RFC 1757.
The following table describes the RMON Configuration Menu options.
RMON Menu options
Table 172
Command
hist
event
alarm
cur

RMON history configuration

Command: /cfg/rmon/hist <1-65535>
[RMON History 1 Menu]
The following table describes the RMON History Menu options.
RMON History Menu options
Table 173
Command
ifoid <1-127 characters>
rbnum <1-65535>
intrval <1-3600>
hist - RMON History Menu
event - RMON Event Menu
alarm - RMON Alarm Menu
cur - Display current RMON configuration
Description
Displays the RMON History Menu.
Displays the RMON Event Menu.
Displays the RMON Alarm Menu.
Displays the current RMON configuration.
ifoid - Set interface MIB object to monitor
rbnum - Set the number of requested buckets
intrval - Set polling interval
owner - Set owner for the RMON group of statistics
delete - Delete this history and restore defaults
cur - Display current history configuration
Description
Configures the interface MIB Object Identifier. The IFOID must correspond to the
standard interface OID, as follows:
1.3.6.1.2.1.2.2.1.1.x
where x is the ifIndex (1-16, 18-21)
The interface OID can have a maximum of 127 characters.
Configures the requested number of buckets, which is the number of discrete
time intervals over which data is to be saved.
The range is from 1 to 65535. The default is 30.
NOTE:
Configures the time interval over which the data is sampled for each bucket.
The range is from 1 to 3600 seconds. The default value is 1800 seconds.
The maximum number of buckets that can be granted is 50.
Configuration Menu
197