Ip Access List Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Table 129 Route Map Configuration Menu options
Command
type 1|2|none
prec <1-255>
enable
disable
delete
cur

IP Access List configuration

Command: /cfg/l3/rmap <1-32>/alist <1-8>
[IP Access List 1 Menu]
The route map number <1-32> and the access list number <1-8> represent the IP access list you wish to
configure. The following table describes the IP Access List Configuration Menu options.
Table 130 IP Access List Configuration Menu options
Command
nwf <1-256>
metric <1-16777214>|none
action permit|deny
enable
disable
delete
cur
Description
Assigns the type of OSPF metric. The default is type 1.
Sets the precedence of the route map. The smaller the value, the higher the
precedence. Default value is 10.
Enables the route map.
Disables the route map.
Deletes the route map.
Displays the current route configuration.
nwf - Network Filter number
metric - Metric
action - Set Network Filter action
enable - Enable Access List
disable - Disable Access List
delete - Delete Access List
current - Display current Access List configuration
1—External routes are calculated using both internal and external
metrics.
2—External routes are calculated using only the external metrics. Type 2
routes have more cost than Type 2.
none—Removes the OSPF metric.
Description
Sets the network filter number.
Sets the metric value in the AS-External (ASE) LSA.
Permits or denies action for the access list.
Enables the access list.
Disables the access list.
Deletes the access list.
Displays the current Access List configuration.
Configuration Menu
163