Radius Server Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Table 80 SSHD Configuration Menu options
Command
off
cur

RADIUS server configuration

Command: /cfg/sys/radius
[RADIUS Server Menu]
prisrv
secsrv
secret
secret2
port
retries
timeout
bckdoor
secbd
on
off
cur
NOTE: See the HP 10Gb Ethernet BL-c Switch Application Guide for information on RADIUS.
The following table describes the RADIUS Server Configuration Menu options.
RADIUS Server Configuration Menu options
Table 81
Command
prisrv <IP address>
secsrv <IP address>
secret <1-32 characters>
secret2 <1-32 characters>
port <UDP port number>
retries <1-3>
timeout <1-10>
bckdoor enable|disable
secbd enable|disable
Description
Disables the SSH server. This is the default for the SSH server.
Displays the current SSH server configuration.
- Set primary RADIUS server address
- Set secondary RADIUS server address
- Set primary RADIUS server secret
- Set secondary RADIUS server secret
- Set RADIUS port
- Set RADIUS server retries
- Set RADIUS server timeout
- Enable/disable RADIUS backdoor for telnet/ssh/http/https
- Enable/disable RADIUS secure backdoor for telnet/ssh/http/https
- Turn RADIUS authentication ON
- Turn RADIUS authentication OFF
- Display current RADIUS configuration
Description
Sets the primary RADIUS server address.
Sets the secondary RADIUS server address.
This is the shared secret between the switch and the RADIUS server(s).
This is the secondary shared secret between the switch and the RADIUS
server(s).
Enter the number of the User Datagram Protocol (UDP) port to be
configured, between 1500-3000. The default is 1645.
Sets the number of failed authentication requests before switching to a
different RADIUS server. The range is 1-3 requests The default is 3 requests.
Sets the amount of time, in seconds, before a RADIUS server authentication
attempt is considered to have failed. The range is 1-10 seconds. The default
is 3 seconds.
Enables or disables the RADIUS back door for telnet/SSH/ HTTP/HTTPS.
This command does not apply when secure backdoor (secbd) is enabled.
Enables or disables the RADIUS back door using secure password for
telnet/SSH/HTTP/HTTPS. This command does not apply when backdoor
(telnet) is enabled.
Configuration Menu
117