Vrrp Virtual Router Group Priority Tracking Configuration; Vrrp Interface Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

VRRP Virtual Router Group Priority Tracking configuration

Command: /cfg/l3/vrrp/group/track
[Virtual Router Group Priority Tracking Menu]
NOTE: If Virtual Router Group Tracking is enabled, the tracking option will be available only under
group option. The tracking setting for the other individual virtual routers will be ignored.
The following table describes the Virtual Router Group Priority Tracking Configuration Menu options.
Virtual Router Group Priority Tracking Configuration Menu options
Table 155
Command
ifs disable|enable
ports disable|enable
cur

VRRP Interface configuration

Command: /cfg/l3/vrrp/if <1-249>
[VRRP Interface 1 Menu]
This menu is used for configuring VRRP authentication parameters for the IP interfaces used with the virtual
routers. The interface-number represents the IP interface on which authentication parameters must be
configured.
The following table describes the VRRP Interface Configuration Menu options.
VRRP Interface Configuration Menu options
Table 156
Command
auth none|password Defines the type of authentication that will be used: none (no authentication), or
passw <password>
del
ifs - Enable/disable tracking other interfaces
ports - Enable/disable tracking VLAN switch ports
cur - Display current VRRP Group Tracking configuration
Description
When enabled, the priority for this virtual router will be increased for each other IP
interface active on this switch. An IP interface is considered active when there is at
least one active port on the same VLAN. This helps elect the virtual routers with the
most available routes as the master. This command is disabled by default.
When enabled, the priority for this virtual router will be increased for each active
port on the same VLAN. A port is considered active if it has a link and is
forwarding traffic. This helps elect the virtual routers with the most available ports
as the master. This command is disabled by default.
Displays the current configuration for priority tracking for this virtual router.
auth - Set authentication types
passw - Set plain-text password
del - Delete interface
cur - Display current VRRP interface configuration
Description
password (password authentication).
Defines a plain text password up to eight characters long. This password will be added
to each VRRP packet transmitted by this interface when password authentication is
chosen (see auth above).
Clears the authentication configuration parameters for this IP interface. The IP interface
itself is not deleted.
Configuration Menu
185