Bootstrap Protocol Relay configuration
Command: /cfg/l3/bootp
[Bootstrap Protocol Relay Menu]
The Bootstrap Protocol (BOOTP) Relay Menu is used to allow hosts to obtain their configurations from a
Dynamic Host Configuration Protocol (DHCP) server. The BOOTP configuration enables the switch to
forward a client request for an IP address to two DHCP/BOOTP servers with IP addresses that have been
configured on the switch.
BOOTP relay is turned off by default.
The following table describes the BOOTP Configuration Menu options.
Table 150
BOOTP Configuration Menu options
Command
addr <IP address>
addr2 <IP address>
on
off
cur
addr
- Set IP address of BOOTP server
addr2
- Set IP address of second BOOTP server
on
- Globally turn BOOTP relay ON
off
- Globally turn BOOTP relay OFF
cur
- Display current BOOTP relay configuration
Description
Sets the IP address of the BOOTP server. For example, 100.10.1.1.
Sets the IP address of the secondary BOOTP server. For example, 100.10.1.2.
Globally turns on BOOTP relay.
Globally turns on BOOTP relay.
Displays the current BOOTP relay configuration.
Configuration Menu
179