HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual page 165

The following table describes the RIP Interface Configuration Menu options.
RIP Interface Configuration Menu options
Table 132
Command
version 1|2|both
supply disable|enable
listen disable|enable
poison disable|enable
split disable|enable
trigg disable|enable
mcast disable|enable
default
none|listen|supply|both
metric <1-15>
auth none|password
key
enable
disable
cur
Description
Configures the RIP version used by this interface.
The default value is version 2.
When enabled, the switch supplies routes to other routers. This command is
enabled by default.
When enabled, the switch learns routes from other routers. This command is
enabled by default.
When enabled, the switch uses split horizon with poisoned reverse. When
disabled, the switch uses only split horizon. The default value is disabled.
Enables or disables split horizon. The default value is enabled.
Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update
messages immediately, even if it is not yet time for the update message. The
default value is enabled.
Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is enabled.
When enabled, the switch accepts RIP default routes from other routers, but
gives them lower priority than configured default gateways. When disabled, the
switch rejects RIP default routes. The default value is disabled.
Configures the route metric, which indicates the relative distance to the
destination. The default value is 1.
Configures the authentication type. The default is none.
Configures the authentication key password.
Enables this RIP interface.
Disables this RIP interface.
Displays the current RIP configuration.
Configuration Menu
165