Arp Cache Options - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

The following table describes the Miscellaneous Debug Menu options:
Miscellaneous Debug Menu options
Table 189
Command
tbuf
snap
clrcfg

ARP cache options

Command: /maint/arp
[Address Resolution Protocol Menu]
The following table describes the Address Resolution Protocol Menu options:
Address Resolution Protocol Menu options
Table 190
Command
find <IP address>
port <port number>
vlan <1-4094>
addr
dump
clear
NOTE:
To display all ARP entries currently held in the switch, or a portion according to one of the
options listed on the menu above (find, port, vlan, dump), see the "ARP information"
section of the "Information Menu" chapter.
Usage
Displays the management processor trace buffer. Header information similar to the following
is shown:
MP trace buffer at 13:28:15 Fri May 25, 2002; mask: 0x2ffdf748
The buffer information is displayed after the header.
Displays the management processor snap (or post-mortem) trace buffer. This buffer contains
information traced at the time that a reset occurred.
Deletes all flash configuration blocks. The next time the switch is rebooted, it returns to the
factory default settings.
find - Show a single ARP entry by IP address
port - Show ARP entries on a single port
vlan - Show ARP entries on a single VLAN
addr - Show ARP entries for switch's interfaces
dump - Show all ARP entries
clear - Clear ARP cache
Usage
Shows a single ARP entry by IP address. For example, 192.4.17.35.
Shows ARP entries on a single port.
Shows ARP entries on a single VLAN.
Shows the list of IP addresses that the switch will respond to for ARP requests.
Shows all ARP entries.
Clears the entire ARP list from switch memory.
Maintenance Menu
217