HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual page 22

The Configuration Menu is displayed.
[Configuration Menu]
sys
port
l2
l3
qos
acl
rmon
pmirr
ufd
dump
ptcfg
gtcfg
cur
3.
From the Configuration Menu, use the following command to select the System Menu:
>> Configuration# sys
The System Menu is displayed.
[System Menu]
syslog
sshd
radius
tacacs+
ntp
ssnmp
access
date
time
timezone
olddst
dlight
idle
notice
bannr
hprompt
bootp
reminders - Enable/disable Reminders
cur
4.
Enter the following command to set the administrator password:
System# access/user/admpw
5.
Enter the current administrator password at the prompt:
Changing ADMINISTRATOR password; validation required...
Enter current administrator password:
NOTE:
If you forget your administrator password, call your technical support representative for help
using the password fix-up mode.
6. Enter the new administrator password at the prompt:
Enter new administrator password:
- System-wide Parameter Menu
- Port Menu
- Layer 2 Menu
- Layer 3 Menu
- QOS Menu
- Access Control List Menu
- RMON Menu
- Port Mirroring Menu
- Uplink Failure Detection Menu
- Dump current configuration to script file
- Backup current configuration to FTP/TFTP server
- Restore current configuration from FTP/TFTP server
- Display current configuration
- Syslog Menu
- SSH Server Menu
- RADIUS Authentication Menu
- TACACS+ Authentication Menu
- NTP Server Menu
- System SNMP Menu
- System Access Menu
- Set system date
- Set system time
- Set system timezone (daylight savings)
- Set system DST for US
- Set system daylight savings
- Set timeout for idle CLI sessions
- Set login notice
- Set login banner
- Enable/disable display hostname (sysName) in CLI prompt
- Enable/disable use of BOOTP
- Display current system-wide parameters
First-time configuration
22