Ospf Interface Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

OSPF Interface configurat
Command: /cfg/l3/ospf/if <1-249>
[OSPF Interface 1
The following table describes the OSPF Interface Configuration Menu options.
Table 137 OSPF Interface Configuration Menu options
Command
aindex <0-2>
prio <0-255>
cost <1-65535>
hello <1-65535>
dead <1-65535>
trans <1-3600>
retra <1-3600>
key <key string>|none Sets the authentication key to clear the password.
mdkey <1-255>|none
enable
disable
delete
cur
on
i
Menu]
aindex - Set area index
prio - Set interface router priority
cost - Set interface cost
hello - Set hello interval in seconds
dead - Set dead interval in seconds
trans - Set transit delay in seconds
retra - Set retransmit interval in seconds
key - Set authentication key
mdkey - Set MD5 key ID
enable - Enable interface
disable - Disable interface
delete - Delete interface
cur - Display current OSPF interface configuration
Description
Configures the OSPF area index.
Configures the assigned priority value to the OSPF interfaces.
(A priority value of 255 is the highest and 1 is the lowest. A priority value of 0
specifies that the interface cannot be used as Designated Router (DR) or Backup
Designated Router (BDR).)
Configures cost set for the selected path—preferred or backup. Usually the cost is
inversely proportional to the bandwidth of the interface. Low cost indicates high
bandwidth.
Configures the interval in seconds between the hello packets for the interfaces.
Configures the health parameters of a hello packet, which is set for an interval of
seconds before declaring a silent router to be down.
Configures the transit delay in seconds.
Configures the retransmit interval in seconds.
Assigns an MD5 key to the interface.
Enables the OSPF interface.
Disables the OSPF interface.
Deletes the OSPF interface.
Displays the current settings for OSPF interface.
Configuration Menu
170