Configuring The Dhcp Server (Cli); Configuring Global Dhcp Server Settings - Dell PowerConnect 7048P Manual

Configuring the DHCP Server (CLI)

This section provides information about the commands you use to configure
and monitor the DHCP server and address pools. For more information about
the commands, see the

Configuring Global DHCP Server Settings

Beginning in Privileged EXEC mode, use the following commands to
configure settings for the DHCP server.
Command
configure
service dhcp
ip dhcp ping packets
ip dhcp conflict logging Enable conflict logging on DHCP server
ip dhcp bootp
automatic
ip dhcp excluded-
lowaddress
address
highaddress
[ ]
exit
show ip dhcp global
configuration
874
Configuring DHCP Server Settings
PowerConnect 7000 Series CLI Reference Guide
Purpose
Enter Global Configuration mode.
Enable the DHCP server.
Specify the number, in a range from 2-10, of packets a
DHCP server sends to a pool address as part of a ping
operation.
Enable the allocation of the addresses to the BootP client.
Specify the IP addresses that a DHCP server should not
assign to DHCP clients. You can specify a single IP
address, or you can specify a contiguous range by using
both the low-address and high-address variables.
Exit to Privileged EXEC mode.
Verify the global DHCP server configuration.
.