Configuring Mld Snooping On Vlans - Dell PowerConnect 7048P Manual

Command
ipv6 mld snooping
seconds
maxresponse
ipv6 mld snooping
immediate-leave
ipv6 mld snooping
seconds
mcrtrexpiretime
CTRL + Z
show ipv6 mld snooping View MLD snooping settings configured on the switch.
show ipv6 mld snooping
interface
interface

Configuring MLD Snooping on VLANs

Beginning in Privileged EXEC mode, use the following commands to
configure MLD snooping settings on VLANs.
Command
configure
vlan database
ipv6 mld snooping
id
ipv6 mld snooping
groupmembership-
vlan-id seconds
interval
Purpose
Specify the leave time-out value for an interface. If an
MLD report for a multicast group is not received within
the number of
period after an MLD leave was received from a specific
interface, the current interface is deleted from the
member list of that multicast group.
Enables MLD snooping immediate-leave mode on the
interface. Enabling immediate-leave allows the switch to
immediately remove the layer 2 LAN interface from its
forwarding table entry upon receiving an MLD leave
message for that multicast group without first sending out
MAC-based general queries to the interface.
Specify the multicast router time-out value for an
interface. This command sets the number of seconds to
wait to age out an automatically-learned multicast router
port.
Exit to Privileged EXEC mode.
View the MLD snooping settings for a specific port, LAG,
or VLAN.
Purpose
Enter global configuration mode.
Enter VLAN Configuration mode.
vlan-
Enable MLD snooping on the specified VLAN.
Specify the host time-out value for the specified VLAN. If
an MLD report for a multicast group is not received in the
number of seconds specified by the
VLAN is deleted from the member list of that multicast
group.
seconds
specified by the leave-time-out
Configuring L2 Multicast Features
seconds
value, this
749