Configuring Local Logging - Dell PowerConnect 7048P Manual

Command
test copper-port tdr
interface
show copper-ports tdr
interface
[ ]
show fiber-ports optical-
interface
transceiver [

Configuring Local Logging

Beginning in Privileged EXEC mode, use the following commands to
configure the type of messages that are logged and where the messages are
logged locally.
Command
configure
logging on
logging audit
logging cli-command
logging web-sessions
logging snmp
260
Monitoring and Logging System Information
Purpose
Perform the Time Domain Reflectometry (TDR) test to
diagnose the quality and characteristics of a copper cable
attached to the specified port.
CAUTION: Issuing the test copper-port tdr command will
bring the interface down.
NOTE:
To ensure accurate measurements, disable all Green
Ethernet modes (EEE or energy-detect mode) on the port
before running the test.
The interface is specified in unit/slot/port format. For
example 1/0/3 is GbE interface 3 on unit 1 of the stack.
Display diagnostic information about all ports or a
specified port.
Display the optical transceiver diagnostics for all ports.
interface
] Include the
specified port.
Purpose
Enter Global Configuration mode.
Globally enables logging.
Enable switch auditing.
Enable CLI command logging
Enable logging of the switch management Web page visits.
Enable logging of SNMP set commands.
option to show information for the