Dell PowerConnect 7048P Manual page 973

Command
ip ospf transmit-delay
seconds
ip ospf mtu-ignore
ip ospf network
{broadcast | point-to-
point}
ip ospf authentication
key
{none | {simple
key key-id
{encrypt
interface-
ip ospf cost
cost
bw
bandwidth
exit
router ospf
passive-interface vlan
vlan-id
Purpose
Set the OSPF Transit Delay for the interface.
seconds
The
seconds it takes to transmit a link state update packet over
this interface. (Range: 1–3600 seconds)
Disable OSPF MTU mismatch detection on the received
database description.
Set the OSPF network type on the interface to broadcast
or point-to-point. OSPF selects a designated router and
originates network LSAs only for broadcast networks. No
more than two OSPF routers may be present on a point-
to-point link.
Set the OSPF Authentication Type and Key for the
} | specified interface.
}}
• encrypt — MD5 encrypted authentication key.
key
• — Authentication key for the specified interface.
(Range: 8 bytes or less if the authentication type is
simple and 16 bytes or less if the type is encrypt.)
key-id
• — Authentication key identifier for the
authentication type encrypt. (Range: 0–25)
Set the metric cost of the interface.
interface-cost
The
metric) of the OSPF interface. (Range: 1–65535)
Set the interface bandwidth used in the formula to
compute link cost for an interface:
link cost = ref_bw÷interface bandwidth
bw
The variable is the interface bandwidth (Range:
1–10000000 Kbps).
Exit to Global Configuration Mode
Enter OSPF configuration mode.
Make an interface passive to prevent OSPF from forming
an adjacency on an interface. OSPF advertises networks
attached to passive interfaces as stub networks.
variable sets the estimated number of
variable specifies the cost (link-state
Configuring OSPF and OSPFv3
973