Configuring Poe Settings (7024P/7048P Only) - Dell PowerConnect 7048P Manual

Configuring PoE Settings (7024P/7048P Only)

Beginning in Privileged EXEC mode, use the following commands to
configure PoE information.
Command
configure
power inline usage-
threshold
threshold
power inline priority
enable
power inline
management {static |
dynamic}
power inline detection
{dot3af | dot3af+legacy
| legacy-only}
interface
interface
power inline {auto |
never}
power inline priority
{critical | high |
medium | low}
Purpose
Enter Global Configuration mode.
Specify the maximum usage for PoE power on the system.
threshold
The variable (range: 12–99%) is a percentage of
total system power.
Enable the port priority feature on the switch.
Set the power-management mode for the switch.
Set the power-management mode for the switch.
• 802.3af-only—IEEE 802.3af detection scheme is used.
• 802.3af+legacy—IEEE 802.3af 4point detection scheme
is used and when it fails to detect a connected PD, legacy
capacitive detection is used.
• legacy-only—only legacy capacitive detection scheme is
used.
Enter interface configuration mode for the specified port.
interface
The variable includes the interface type and
number, for example gigabitethernet 1/0/3.
Set the PoE device discovery admin mode.
• auto — Enables the device discovery protocol and, if
found, supplies power to the device.
• never — Disables the device discovery protocol and stops
supplying power to the device.
Configures the port priority level for the delivery of power
to an attached device.
Managing General System Settings
305