Dell PowerConnect 7048P Manual page 978

Configuring OSPF Route Redistribution Settings
Beginning in Privileged EXEC mode, use the following commands to
configure OSPF route redistribution settings.
Command
configure
router ospf
distribute-list
accesslistname
static | connected}
redistribute {rip | static |
connected} [metric
integer
] [metric-type {1 |
integer
2}] [tag
978
Configuring OSPF and OSPFv3
Purpose
Enter global configuration mode.
Enter OSPF configuration mode.
Specify the access list to filter routes received from the
out {rip | source protocol. The ACL must already exist on the
switch. For information about the commands you use to
configure ACLs, see "Configuring ACLs (CLI)" on
page 558.
accesslistname
•
ACL.
• rip — Apply the specified access list when RIP is the
source protocol.
• static — Apply the specified access list when packets
come through the static route.
• connected — Apply the specified access list when
packets come from a directly connected route.
Configure OSPF to allow redistribution of routes from
the specified source protocol/routers.
• rip — Specifies RIP as the source protocol.
] [subnets]
• static — Specifies that the source is a static route.
• connected — Specifies that the source is a directly
connected route.
metric
•
redistributing the route. (Range: 0–16777214)
• metric-type 1 — Type 1 external route.
• metric-type 2 — Type 2 external route.
tag
•
0–4294967295)
• subnets—Unless this keyword is configured, OSPF
distributes only class A, class B, and class C prefixes.
— The name used to identify an existing
— Specifies the metric to use when
— Value attached to each external route. (Range: