Trap Flags - Dell PowerConnect 7048P Manual

Powerconnect 7000 series stackable layer 2 and 3 switches

Hide thumbs Also See for PowerConnect 7048P:

Table of Contents

Trap Flags

The Trap Flags page is used to specify which traps you want to enable or

disable. When the condition identified by an active trap is encountered by

the switch, a trap message is sent to any enabled SNMP Trap Receivers, and a

message is written to the trap log.

To access the Trap Flags page, click Statistics/RMON → Trap Manager →

Trap Flags in the navigation panel.

Figure 12-15. Trap Flags

Configuring SNMP